Wall ovens are built into the cabinetry here more often than they stand free, and getting one out is a two-person job done carefully. We bring the second pair of hands rather than improvising.
Every day: 7:00 AM – 11:00 PM
Set to 350, baking like 310. A drifting sensor is the usual reason and an easy one to confirm.
Igniters on gas, elements on electric. Both fail gradually and then completely.
Hinges sag and the seal stops meeting the frame, so heat escapes and nothing browns evenly.
Bake and broil run on separate circuits, which is why half an oven can die on its own.
Control boards report faults in numbers. Reading them saves replacing parts that were never broken.
A common one. The heat that cleans also takes out fuses and thermostats on the way.
Diagnosis happens at the machine, not over the phone. These three account for most of what we find, and the common parts travel with us.
Temperature sensor
Cheap, fails often, and responsible for most complaints about uneven baking.
Bake element or igniter
The part that actually makes heat, and the first thing we test.
Door hinges and seal
Worn hinges let the door sit proud, and everything downstream of that is heat loss.
Four in five homes in Addison are rented. Tell us at the booking who pays and who holds the key, and the invoice goes to the right place while access gets arranged with the front desk or the leasing office.
Looking for something other than oven repair? The appliance repair in Addison, TX page lists every machine we work on.
Addison post runs through a few neighboring codes along the Beltway. If yours is not listed, call and we will check the address against the town line.
Leave a number and we set the window on the call. If the machine sits in a building with a front desk or a leasing office, say so then and the access gets arranged from our end.
We answer every day from 7:00 AM until 11:00 PM.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
We have it. Expect a call back shortly to agree the visit window.
Yes. Built-ins come out on their rails and go back level, and the surround is protected while they are out.
Yes. Each cavity has its own element and sensor, so often only one half needs work.
Both, including dual-fuel ranges with a gas top and an electric oven.
Usually a sensor, and among the least expensive repairs we do.
We check it against a separate thermometer on two shelves before leaving.
