Cooktops here are mostly drop-in: four burners set into a stone counter with no range underneath. That changes how the work is done, and it changes what can be replaced in place.
Every day: 7:00 AM – 11:00 PM
The igniter sparks and the gas is not arriving, or the port is blocked. Two different fixes, one symptom.
Switches and elements fail individually, so the rest of the top carries on as though nothing happened.
Overheat protection, a cooling fan, or a pan the hob no longer recognizes. Diagnosis separates them quickly.
Shut the valve, open a window, and ring us. Calls like this jump the queue.
A cracked ceramic top is not something to keep using. We confirm whether the top alone can be replaced.
Valve stems seize with heat and time, and the control stops reaching the burner.
Diagnosis happens at the machine, not over the phone. These three account for most of what we find, and the common parts travel with us.
Surface element or burner head
The part that takes the heat, and therefore the part that goes first.
Infinite switch
Controls the element on electric tops, and fails in a way that reads as a dead burner.
Spark module
On gas, one failed module can leave every burner clicking at once.
Four in five homes in Addison are rented. Tell us at the booking who pays and who holds the key, and the invoice goes to the right place while access gets arranged with the front desk or the leasing office.
Looking for something other than stove and cooktop repair? The appliance repair in Addison, TX page lists every machine we work on.
Addison post runs through a few neighboring codes along the Beltway. If yours is not listed, call and we will check the address against the town line.
Leave a number and we set the window on the call. If the machine sits in a building with a front desk or a leasing office, say so then and the access gets arranged from our end.
We answer every day from 7:00 AM until 11:00 PM.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
We have it. Expect a call back shortly to agree the visit window.
Yes. Induction tops fail differently from radiant ones, usually at the fan or the power board rather than the surface.
A cracked ceramic surface gets swapped, not repaired. Whether the cost makes sense against the age of the hob is something we tell you before ordering anything.
In most cases, yes. The unit lifts out of its cutout and the stone stays where it is.
All three. Say which when booking so the right parts travel with us.
Close the supply, get some air through the room, and phone straight away rather than using the form.
